Court Construction
A regulation court built on a properly graded base, with UV-stable surfacing and line marking, ready for year-round outdoor play.
What Goes Wrong
The problems that show up months after a court is finished almost always trace back to decisions made before the base was poured.
A base poured without a verified drainage slope traps water on the surface after every Central Florida afternoon storm.
The drainage slope and any needed outlets are confirmed during the site assessment, before grading or pouring begins.
Sandy soil and a high water table can cause an under-compacted sub-base to shift, cracking the surface within one rainy season.
Sub-base compaction is tested and confirmed before the concrete or asphalt base is placed, removing the main cause of early cracking.
Acrylic coating applied before the base has fully cured delaminates from the surface, peeling and bubbling within months.
The builder holds the required cure interval between base placement and surface coating to prevent delamination and peeling.
Treating net posts, fencing, and lighting as add-ons after the build creates follow-up visits, extra mobilisation costs, and surface damage.
Net post sleeves, fencing footings, and lighting conduit are built into the original scope so the court is complete in one mobilisation.
Scope of Work
A complete installation addresses every layer of the build, from raw ground to a playable surface with all accessories in place.
Ground is graded to a verified drainage slope and low spots are corrected before any base material is placed.
A compacted sub-base and poured concrete or asphalt layer form the stable foundation the surface coating bonds to.
UV-stable acrylic coating applied in multiple passes gives consistent ball response and resists Florida’s intense sun exposure.
Court lines are painted to USA Pickleball specifications, including kitchen, service, and centerline markings.
Permanent net post sleeves are set in the base so the net system sits at the regulation 36-inch sideline height.
Chain-link or vinyl-coated fencing and court lighting are scoped and installed as part of the same build mobilisation.
Snap-together tile for sites where a poured base is not practical.
Worn or cracked acrylic surfaces recoated and relined.
Multi-court layouts for shared residential facilities.
Why Choose Us
Local site knowledge, a structured build process, and a written scope before any work begins set this apart from a general contractor quoting blind.
Every enquiry starts with an on-site evaluation of the space and drainage slope, not a phone estimate.
Base prep, surfacing, fencing, lighting, and line marking are listed as separate line items so nothing is hidden.
Every scope accounts for sandy soil and high water table conditions specific to the Orlando area.
Net posts, fencing, and line marking are finished in the same visit, not scheduled as separate follow-up jobs.
The finished court is walked through with the customer before the job is considered complete and closed.
Courts built for home lots, HOA facilities, schools, and commercial sites across the greater Orlando area.
The Process
01
Submit your site details. An on-site visit assesses the ground, drainage slope, and available footprint in person.
02
You receive an itemised estimate covering base preparation, surface coating, fencing, lighting, and line marking as separate line items.
03
The builder completes grading, base, surfacing, and accessories in one mobilisation, then walks the finished court with you before sign-off.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Backyard pickleball court | $20,000-$50,000 |
| Commercial outdoor pickleball court | $20,000-$45,000 |
| Premium cushioned court | $29,000-$48,000 |
| Small court complex | $180,000-$500,000 |
Tell us the site and the sport. We schedule a ground and drainage assessment and put the full scope in writing, no commitment required.